Product display-Camera direct reading water meter
Here:Home > Product display > Camera direct reading water meter > IC card water control machine
Product Center

Service hotline:

15814469667 Ms.Chen
Camera direct reading water meter
IC card water control machine
  • IC card water control machine
IC card water control machine

The water control machine is widely used in campus, enterprises, government offices' water rooms, bathhouses, apartments and other internal water use occasions. It can realize simple and convenient installation and water consumption control, realize electronic and intelligent transactions and settlement, improve users' management efficiency and management means, and is the most important part of campus and enterprise all-in-one card. It has the advantages of small size, low power consumption, long service life, complete functions, water theft prevention, power off and valve closing, etc. The flow accuracy is within 5 ‰, and the copper body is used, which is high in temperature resistance

Service hotline:

15814469667 Ms.Chen

Product parameters

function describe
Billing mode Measurement and timing
Type of read-write card MIFARE compliant cards (S50, S70), CPU cards
working frequency 13.56MHZ
Reading and writing time <0.2 second
Read-write distance 25mm—50mm(Card can be put in)
CPU type 32-bit ARM processor
Show Multi function LED display
Card issuing capacity Unlimited (offline)
Maximum recording amount 40 million (offline)
storage capacity Cumulative consumption times and total amount
Data saving 10 years (Flash saves data without loss in case of power failure)
Billing accuracy 0.01 ¥
Applicable water temperature 0℃∽100℃
working voltage DC12V ± 5%, power consumption < 5W
Overall dimensions 145mm×80mm×76mm(Long × wide × High)
Weight 600g
Operating environment Temperature: - 20 ℃~ 60 ℃, relative humidity: 10% ~ 90%



installation diagram
image.png
                              
The wiring mode of independent power supply is adopted. The power bus of the water control machine and the valve power bus are respectively P and N lines, and the branch lines leading from the bus to the terminal are respectively P1 and N1 lines;
P wire requirements: the section of copper wire shall not be less than 1.5 mm2
N-wire requirements: copper wire section is greater than 1.5 mm2
P1 wire requirements: copper wire section is not less than 0.5 mm2
Requirement for N1 wire: the section of copper wire is greater than 0.5 mm2


Recommended products